|
| |
TM 5-2420-222-20-2
FUEL GAGE SENDER
This task covers:
a. Removal (page 2-662)
c.
Inspection/Replacement (page 2-664)
b. Cleaning (page 2-663)
d.
Installation (page 2-665)
INITIAL SETUP
Tools
Personnel Required
Brush, wire
Two
Screwdriver, flat-tip, 1/4-inch
Equipment Condition
Materials/Parts
1.
Fuel tank drained (page 2-250)
Gasket, fuel gage sender
2.
Right side grille removed
Lockwasher, sender terminal screw
(TM - 52420-222-10)
Rags, wiping (item 21, Appendix C)
Sealing compound, gasket
(item 23, Appendix C)
Solvent, drycleaning
(item 28, Appendix C)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
No open flames, welding, grinding, smoking, or use of heat producing devices permitted near fuel
tank and fuel lines during maintenance unless the fuel tank has been cleaned and purged of all
flammable liquids and vapors. Fuel burns easily and fumes are explosive. Keep battery
disconnected. Failure to observe these precautions could cause serious injury.
1. Sender (1) and
Screw (3),
Using 1/4-inch flat-tip screwdriver,
terminal (2)
lockwasher (4),
loosen.
and washer (5)
2. Screw (3),
Terminal (2)
a.
Tag (page 2-137).
lockwasher (4),
b.
Take out.
and washer (5)
3. Sender (1)
Screw (3),
a.
Unscrew and take out.
lockwasher (4),
b.
Get rid of lockwasher (4).
and washer (5)
2-662
|
