|
| |
TM 5-2420-222-20-2
TURN SIGNAL SWITCH - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
6. Reverser control
Spring pin (3)
Using 5/32-inch straight drive-pin punch,
lever (1) and
and 1-pound head ball-peen hammer, drive
neutral latch (2)
out.
7. Reverser control
Neutral latch (2)
Take off.
lever (1)
8. Dash (4) and
Grommet (6)
Using 1/4-inch flat-tip screwdriver,
cable (5)
pry up and take out.
9. Bracket (7),
Two screws (10)
Using 7/16-inch box wrench, unscrew and
dash (4), cowl (8),
take out.
and two U-type
clip nuts (9)
10. Cowl (8) and
Dash (4) with
Lift up enough to access screws (12).
five U-type clip
assembled parts
nuts (9 and 11)
11. Dash (4),
Two screws (12)
a.
Using 1-inch blade, 7/32-inch flat-tip
bracket (7), and
and lockwashers (14)
screwdriver, unscrew and take out.
turn signal
b.
Get rid of lockwasher(14).
switch (13)
12. Dash (4)
Turn signal
Note routing of cable (5) for proper
switch (13) with
placement during installation, take out.
assembled cable (5)
and bracket (7)
13. Turn signal
Bracket (7)
Take off.
switch (13)
14. Cowl (8)
Dash (4) with
Set back in place.
assembled parts
DISASSEMBLY
NOTE
For turn signal switch disassembly, go to Turn Signal Switch In-Line Fuse (page 2-
602).
2-596
|
