|
| |
TM 5-2420-222-20-2
TURN SIGNAL SWITCH
This task covers:
a. Removal (page 2-594)
e. Repair (page 2-598)
b. Disassembly (page 2-596)
f. Assembly (page 2-599)
c. Cleaning (page 2-597)
g. Installation (page 2-599)
d. Inspection/Replacement (page 2-598)
INITIAL SETUP:
Tools
Materials/Parts - Continued
Hammer, ball-peen, 1-pound head
Rags, wiping (item 21, Appendix C)
Screwdriver, flat-tip, 1/8-inch
Solvent, drycleaning (item 28, Appendix C)
Screwdriver, flat-tip, 1/4-inch
Tags, marking (item 30, Appendix C)
Screwdriver, flat-tip, 7/32-inch
1-inch blade
Personnel Required
Punch, drive-pin, straight, 5/32-inch
Wrench, box, 3/8-inch
One
Materials/Parts
Equipment Condition
Cleaning compound, solvent
1.
Battery ground cable disconnected
(item 4, Appendix C)
page 2-696)
Lockwasher, circuit breaker
2.
Cowl front cover removed (page 2-1020)
terminal nut
3.
Plexiglass dash cover removed
Lockwasher, turn signal switch
(page 2-576)
screw (two required)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
Warning flasher terminal connects to 20 ampere circuit breaker front terminal on
loader backhoes with Serial Numbers 235786 thru 235999 and to rear terminal on
loader backhoes with Serial Numbers 319995 thru 342573.
1.
Warning flasher
Nut (4) and
a.
Using 3/8-inch box wrench, unscrew
terminal (1) and
lockwasher (5)
and take off.
terminal (2 or 3)
b.
Get rid of lockwasher (5).
2.
Terminal (2 or 3)
Warning flasher
a.
Tag (page 2-137).
and nut (6 or 7)
terminal (1)
b.
Take off.
2-594
|
