|
| |
TM 5-2420-222-20-2
DASH - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
2. Neutral latch (1)
Spring pin (3)
Using 1-pound head ball-peen hammer and
and reverser
and 5/32-inch straight drive-pin punch,
control lever (2)
drive out.
3. Reverser control
Neutral latch (1)
Take off.
lever (2)
4. Reverser control
Special washer (4)
Take off.
lever (2), washer
(4), and dash (5)
5. Main wiring harness
Cowl wiring
a.
Tag (page 2-137).
connector (6)
harness
b.
Using 1/8-inch flat-tip screwdriver,
connector (7)
lift tab and unplug.
6. Connector (8)
Dash light
a.
Tag (page 2-137).
connector (9)
b.
Unplug.
7. Warning light
Connector (11)
a.
Tag (page 2-137).
flasher three
b.
Unplug.
terminals (10)
8. Connector (12)
Warning light
a.
Tag (page 2-137).
connector (13)
b.
Using 1/8-inch flat-tip screwdriver,
lift tab on connector (12) and unplug.
9. Connector (14)
Warning light
a.
Tag (page 2-137).
connector (15)
b.
Using 1/8-inch flat-tip screwdriver,
lift tab on connector (14) and unplug.
NOTE
On loader backhoe, warning flasher terminal connects to 20 ampere circuit breaker
front terminal for Serial Nos. 235786 thru 235999 and rear terminal for Serial Nos.
31995 thru 342573.
10. Warning flasher
Nut (19) and
a.
Using 3/8-inch box wrench, unscrew
terminal (16) and
lockwasher (20)
and take off.
terminal (17 and 18)
b.
Get rid of lockwasher (20).
11. Terminal (17 and 18)
Warning flasher
a.
Tag (page 2-137).
and nut (21 and 22)
terminal (16)
b.
Take off.
12. Tachometer drive
Nut (25)
Unscrew and pull back.
cable (23) and
tachometer (24)
2-580
|
