ADJUSTMENT -624880395

TM 5-2420-222-20-1

ACCELERATOR PEDAL, FOOT ACCELERATOR ROD, AND SPEED CONTROL ARMS - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

ADJUSTMENT - CONTINUED

NOTE

If distance measured in step 31 was correct, skip steps 32 thru 40.

32.

Yoke (1) and

Cotter pin (3)

a. If not already removed, using sllp-

pin (2)

joint pliers, straighten ends and pull out.

b. If not replaced during installation, get rid of.

33.

Yoke (1) and

Nut (5)

Using 7/16-inch open-end wrench,

rod (4)

loosen.

34.

Yoke (1) and

Pin (2)

Take out.

pedal (6)

35.

Pedal (6)

Yoke (1)

Take off.

36.

Rod (4)

Yoke (1)

a. If distance measured in step 31 was less than

1/8-inch (3 mm), turn counterclockwise to

lengthen linkage.

b. If distance measured in step 31 was more than

11/32-inch (9 mm), turn clockwise to shorten

linkage.

37.

Pedal (6)

Yoke (1)

Place in position.

Yoke (1) and

Pin (2)

a. Push in.

pedal (6)

b. Repeat steps 31 thru 38.

NOTE

If cotter pin has just been replaced during installation, it may be reused after adjustment,

otherwise use new cotter pin.

39.

Yoke (1) and

Cotter pin (3)

a. place in position.

pin (2)

b. Using slip-joint pliers, bend ends back.

40.

Yoke (1) and

Nut (5)

Using 7/16-inch open-end wrench, tighten

rod (4)

until seated against yoke (1).

2-334