 |
|||
|
|
|||
|
Page Title:
HAND THROTTLE LEVER AND CABLE ADJUSTMENT - CONTINUED |
|
||
| ||||||||||
|
|
 TM 5-2420-222-20-1
HAND THROTTLE LEVER AND CABLE ADJUSTMENT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT - CONTINUED
15.
Bracket (1) and
Two screws (3)
a. Using 7/16-inch open-end wrench,
stop (2)
tighten.
There must be enough clearance be-
tween stop and loader control box to
allow throttle lever to pass stop.
b. Repeat step 12 thru 15.
16.
Loader backhoe
Engine asembly
Shut down (TM 5-2420-222-10).
17.
Loader control
Throttle lever (5)
Using 0 to 50-pound range dial indicating
box (4) and
scale, measure force of pull required to
bracket (1)
move forward from slow idle position (rear)
to throttle stop position (front).
Force of pull should measure
10 pounds (44 N).
NOTE
If force of pull is correct, skip step 18.
18.
Bracket (1)
Nut (6)
a. If force of pull is more than 10 pounds
(44 N), using 9/16-inch open-end
wrench, loosen.
b. If force of pull is less than 10 pounds
(44 N), using 9/16-inch open-end
wrench, tighten.
c. Repeat steps 17 and 18.
2-314
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals