 |
|||
|
|
|||
|
Page Title:
HAND THROTTLE LEVER AND CABLE ADJUSTMENT - CONTINUED |
|
||
| ||||||||||
|
|
 TM 5-2420-222-20-1
HAND THROTTLE LEVER AND CABLE ADJUSTMENT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT - CONTINUED
2.
Loader control
Throttle lever (2)
a. Push all the way forward and note
box (1)
engine speed on tachometer (3).
Engine speed should be 2650 rpm.
b. Pull all the way back and note engine
speed on tachometer (3).
Engine speed should be 800 to
825 rpm.
NOTE
If engine speeds are correct, skip steps 3 thru 11.
3.
Swivel (4) and
Cotter pin (6)
a. Using slip-joint pliers, straighten
clip (5)
ends and pull out.
b. If not just replaced, get rid of.
4.
Swivel (4),
Clip (5)
Using slip-joint pliers, unsnap from
throttle lever (2),
cable (7).
and cable (7) MF
5.
Throttle lever (2)
Swivel (4) with
Take out.
and clip (5)
attached cable (7)
6.
Throttle lever (2)
Clip (5)
Take off.
7.
Throttle lever (2)
Swivel (4)
a. Make sure throttle lever (2) is all
and cable (7)
the way back.
b. Using 112-inch open-end wrench,
screw in or out until alined with
throttle lever hole.
8.
Throttle lever (2)
Clip (5)
Place in position.
9.
Throttle lever (2)
Swivel (4) with
Place in position.
and clip (5)
attached cable (7)
10.
Swivel (4),
Clip (5)
a. Snap onto cable (7).
throttle lever (2),
b. Repeat steps 2 thru 10.
and cable (7)
NOTE
If cotter pin was just replaced during lever or cable installation, it may be reused.
2-312
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals