INSTALLATION - CONTINUED -624880365

TM 5-2420-222-20-1

ENGINE STARTING AID FLUID INJECTION SOLENOID - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

INSTALLATION - CONTINUED

28.

Engine assembly

Fuel filter

Install (page 2-277).

assembly

WARNING

Ether burns easily. If engine starting aid is not properly installed, do not release ether in confined areas or

near open flame. Engine primer fluid cylinder is pressurized to expel ether when fluid injection solenoid is

activated. Do not heat engine primer fluid cylinder or place it in fire.

29.

Bracket (1) and

Solenoid (3) with

Place in position.

terminal (2)

assembled parts

30.

Bracket (1),

Two screws (4), new

Screw together and tighten using 1/2-inch,

solenoid (3), and

lockwashers (5),

3/8-inch drive socket, 5-inch extension,

terminal (2)

washers (6) and

ratchet handle, and 1/2-inch box wrench.

nuts (7)

NOTE

Steps 31 and 32 only apply to loader backhoes with Serial Numbers 319995 thru 342573.

WARNING

Ether burns easily. If engine starting aid is not properly installed, do not release ether in confined areas or

near open flame. Engine primer fluid cylinder is pressurized to expel ether when fluid injection solenoid is

activated. Do not heat engine primer fluid cylinder or place it in fire.

31.

Hood (8) and

Solenoid (3) with

Place in position.

terminal (2)

attached parts

32.

Hood (8),

Two screws (9), new

Screw together and tighten using 1/2-inch,

solenoid (3), and

lockwashers (10),

3/8-inch drive socket, ratchet handle, and

terminal (2)

washers (11),

1/2-inch box wrench.

spacers (12), and

nuts (13)

33.

Elbow (14)

Tube (15)

a. Uncap.

b. Screw on and tighten using 3/8-inch

open-end wrench.

34.

Solenoid terminals

Solenoid lead

Push on.

(16 and 17)

connector (18)

2-304