ASSEMBLY -624880271

TM 5-2420-222-20-1

FUEL INJECTION CAPS AND HOSES - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

ASSEMBLY

WARNING

No open flames, welding, grinding, smoking, or use of heat producing devices permitted near fuel tank

and fuel lines during maintenance unless the fuel tank has been cleaned and purged of all flammable

liquids and vapors. Fuel burns easily and fumes are explosive. Keep battery disconnected. Failure to

observe these precautions could cause serious injury.

NOTE

There are four caps and three hoses which connect in series. One connection is shown. Repeat steps 20

thru 22 for remaining connections.

New hoses are manufactured to required length from bulk items. For more information on manufacturing

new hoses, go to Appendix D.

20.

Hose (1)

Nut (2) and

Place in position.

grommet (3)

21.

Cap (4)

Hose (1) with

Place in position.

assembled parts

22.

Cap (4) and

Nut (3)

a. Screw on and tighten using 9/16-inch

hose (1)

open-end wrench.

b. Repeat steps 20 thru 22 for remaining

connections.

INSTALLATION

WARNING

No open flames, welding, grinding, smoking, or use of heat producing devices permitted near fuel tank

and fuel lines during maintenance unless the fuel tank has been cleaned and purged of all flammable

liquids and vapors. Fuel burns easily and fumes are explosive. Keep battery disconnected. Failure to

observe these precautions could cause serious injury.

23.

Four nozzles (5)

Four nuts (6)

a. Uncap nozzles (5).

and grommets (7)

b. Place in position.

24.

Four caps (4, 8,

Place in position.

9, and 10) with

assembled parts

2-210