FUEL INJECTION NOZZLES - CONTINUED
0 to 150 foot-pound capacity torque
wrench, and 3/4-inch open-end
wrench, tighten to 35 foot-pounds
(47 N.m) torque.
Three clamps (2)
Place in position.
Three clamps (2),
Spacer (4) and
a. Screw in and tighten until snug using
1/2-inch, 3/8-inch drive socket, 5-
nozzle (1), spacer
inch extension, and ratchet handle.
(3), and cylinder
b. Using 112-inch, 3/8-inch drive socket,
5-inch extension, 1/2-inch female to
3/8-inch male socket wrench adapter,
and 0 to 150 foot-pound capacity
torque wrench, tighten to 20 foot-
pounds (27 N.m) torque.
Fuel injection caps
Install (page 2-206).
Start and run at high idle
a. Check for leaks.
b. If leaking at any connection, shut
down engine (TM 5-2420-222-10) and
replace defective component as out-
lined in this task.
c. If found leaking, repeat steps 21
Shut down (TM 5-2420-222-10).