LUBRICATING COOLER-TO-WATER PUMP COOLANT LINES - CONTINUED
INSTALLATION - CONTINUED
Plate (1) and
Screw (3) and
Screw in and tighten using 9/16-inch,
new lockwasher (4)
1/2-inch drive socket and ratchet handle.
Fan blade and
Install (page 2-431).
Do not shut down engine at this time.
Run at high idle (TM 5-2420-222-10).
a. Check for leaks.
b. If leaking at any connection, tighten
clamp using 1/4-inch flat-tip
c. If leaking does not stop, shut down
engine (TM 52420-222-10) and
replace defective component as
outlined in this task.
If coolant leak was found, fill
If still running, shut down