 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-30. ACCESSORY DRIVE COVER ASSEMBLY - REPLACE (Cont'd)
(6) If necessary, remove two washers
(15), pins (16) and plug (18).
Use a bearing puller to remove
bearings (17) from cover
assembly (7).
b. Installation
(1) If removed, install two bearings
(17) and pins (16) into case (7)
and place washers (15) onto pins.
Install plug (18).
(2) If removed, insert three studs
(14) into flywheel housing.
(3) Put seal (9) and gasket (8) in
place on flywheel housing.
(4) Install cover assembly (7) on
three studs (14) in flywheel
housing. Secure cover assembly
on studs with three washers (6)
and three nuts (5). Tighten
using a wrench.
(5) Install thirteen capscrews (4)
around cover assembly. Tighten
using a wrench.
(6) If required install cover (2)
and gasket (3) to cover
assembly. Secure with six
capscrews (l). Tighten using a
wrench.
(7) Install hydraulic pump. See
TM5-241O-237-2O.
(8) If required,, install cover (10)
and seal (13) to cover assembly.
Secure with two capscrews (11)
and two washers (12). Tighten
using a wrench.
(9) Install dash assembly. See page
11-8.
c. Place In Service
Run engine and check for proper
operation.
3-127/(3-128 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals