 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
(6) Use a wrench to remove four
capscrews (12) from gear (13).
Remove gear (13) from the engine.
(7) Remove the timing gear plate
(page 3-89). - -
b. Installation
(1) Install the timing gear plate
(1A) Locate no. 1 cylinder TDC (top
dead center) on the compression
stroke. See TM5-241O-237-2O.
(2) With the engine set at TDC,
install camshaft gear (13) so
that the "C" mark on the
camshaft gear is aligned with
the "C" mark on the crankshaft
gear (14).
(3) Use a wrench to install four
capscrews (12) that secure
camshaft gear (13). Tighten to
35-45 lb. ft.
(4) Place shaft (11) and lock (10)
into position and use a wrench to
install capscrew (8) and nut (9).
Bend tabs over on lock (10).
(5) If removed, install bearing (7)
into gear (6) using a press so
bearing is 0.060" below the
outside surface. Bearing
diameter after installation
must be 1.37810.0019 in.
(6) Install gear (6) on shaft (11)
and install washer and two
capscrews (4) that secure gear
(6). Use a wrench to tighten
capscrews (4).
(7) Refer to page 4-26 to install
timing pin in fuel injection
pump.
3-109
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals