 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-17. FLYWHEEL HOUSING - REPLACE/REPAIR (Cont'd)
(5) Use a wrench to install plug
(13).
(6) Use a wrench to install plug
(12).
(7) Position two brackets (11) on
flywheel housing (6) and use a
wrench to install four washers
(10) and capscrews (9).
(8) Install rear accessory drive
gears. See page 3-124.
(9) Install rear accessory drive gear
cover assembly. See page 3-126.
d. Installation
(1) Install new gasket (8) on fly-
wheel housing (6).
(2) Use lifting equipment to place
flywheel housing (6) in position
against the cylinder block.
(3) Install thirteen capscrews (7)
that hold flywheel housing (6) in
place. Make sure the two shorter
capscrews (7) go into positions 7
and 2.
(4) Use a wrench to tighten thirteen
capscrews (7) in the order shown
to 7510 lb. ft.
(5) Cut gasket (8) even with the oil
pan face of the cylinder block.
(6) Put clean grease on washer (5)
and install in flywheel housing
(6).
3-75
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals