 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-15. CRANKSHAFT VIBRATION DAMPER - REPLACE (Cont'd)
d. Installation
(1) Install the crankshaft pulley.
See page 3-65.
(2) Lubricate the outside diameter of
the front oil seal on the
crankshaft and the inside sealing
surface of the hub (10) with
clean OE/HDO 30 lubricating oil.
(3) Put hub and pulley assembly on
the end of crankshaft.
(4) Use a push-puller tool to pull
the hub and pulley assembly onto
the crankshaft until the hub (10)
contacts the crankshaft gear.
(5) Remove push-puller tool and
install washer (8), maximum flat
surface towards hub (10), and
capscrew (7). Use a wrench to
tighten capscrew to a torque of
23020 lb. ft. Tap end of
capscrew with a hammer and again
tighten capscrew to a torque of
23020 lb. ft.
(6) put adapter (6) in position on
hub (10).
(7) Install two Vee belts (5).
(8) Put vibration damper (2) in
position on the hub (6), and
install six capscrews (1). Use a
wrench to tighten capscrews to
7510 lb. ft.
(9) Install radiator. See page 5-4.
(10) Use a suitable belt tension gauge
to measure belt tension. Measure
the belt nearest the radiator.
(11) Use a wrench to tighten bottom
nut (3) on adjustment rod (4)
until belt tension gauge reads
1205 lbs.
3-69
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals