 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-12. CRANKSHAFT FRONT SEAL AND WEAR SLEEVE - REPLACE (Cont'd)
(3) Put wear sleeve distorter (3)
between the distorter ring (2)
and the wear sleeve (4). Turn
until the edge of the distorter
makes a crease in the wear sleeve.
Make additional creases in the
wear sleeve until the wear sleeve
is loose. Remove distorter ring
and the wear sleeve. Discard
wear sleeve.
b.
Installation
NOTE
The wear sleeve and crankshaft
front seal must be installed
together.
(1) Apply clean lubricating oil on
the seal lip of seal (1) and on
the outside diameter of the wear
sleeve (4).
(2) Install seal (1) on the wear
sleeve (4) as shown, with the lip
of the seal towards the side of
the sear sleeve that has the
chamfer on the inside diameter.
(3) Clean the inside diameter of the
wear sleeve (4) and the tapered
surface of the crankshaft (5)
with quick cure primer.
(4) Apply Loctite 262 to surfaces on
the inside diameter of the wear
sleeve (4) and on the crankshaft
(5).
(5) Put wear sleeve (4) and seal (1)
on the crankshaft, with the lip
of the seal towards the engine.
(6) Install the wear sleeve and seal
installer tool. Apply a small
amount of lubricating oil between
capscrew and installer tool.
3-60
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals