 |
|||
|
|
|||
|
Page Title:
ENGINE ASSEMBLY - REPLACE - continued |
|
||
| ||||||||||
|
|
 TM5-241O-237-34
3-4. ENGINE ASSEMBLY - REPLACE (Cont'd)
NOTE
If more than one hydraulic line is
to be removed, identify lines to
assure proper installation. Use
suitable container to catch any
hydraulic oil that may drain from
the system.
CAUTION
Wipe the area clean around all
hydraulic connections to be opened
during removal and disassembly.
Cap oil lines and plug holes after
removing lines. Contamination of
the hydraulic system could result
in premature failure!
(10) Use a wrench to remove four
capscrews (22), four washers
(23), and two flange halves
(24) holding hose assembly (21)
to oil cooler tube assembly.
Remove and discard seal (25).
(11) Disconnect vent line (26) from
the torque divider by using a
wrench to remove two capscrews
(27), two flat washers (28), and
gasket (29). Discard gasket (29).
(12) Disconnect oil supply line (30)
for the transmission using a
wrench to remove two capscrews
(31), flat washer (32), and
seal (33). Discard seal (33).
(13) Disconnect two lines (34 and
35) from sequence relief valve
using a wrench to remove eight
capscrews (36), washers (37),
and four split flanges (38).
(14) Use a wrench to remove two
clamps (39) that attach two
lines (40 and 41) to torque
divider.
(15) Use a wrench to remove line
(42) from sequence relief valve.
3-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals