Gears.

TM5-241O-237-34

(3) Broken studs can be removed by welding bar stock or a nut to stud and

removing with wrench.

(4) Install replacement stud slowly to prevent heat buildup and snapping off.

Gears.

(1) Remove gears using pullers.

Remove minor nicks, burrs or

(2) Only minor repairs to gears are permitted.

scratches on gear teeth with:

(a) Fine mill file.

(b) Crocus cloth dipped in cleaning solvent.

(3) If keyways are worn or enlarged, replace gear.

Bushings and Bushing Type Bearings. When bushings and bushing type

bearings seize to a shaft and spin in the bore, the associated part must

also be replaced.

Oil Seals.

(1) Remove oil seals by pressing or prying out, being careful not to damage

casting or adapter bore.

(2) Always install new seal in bore using proper seal replacing tool.

2-14. PAINTING

Upon installation, restored parts must be painted per TB 43-0209.

2-35/(2-36 Blank)