 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
WINCH ASSEMBLY REPAIR - CONTINUED
0245 19
ASSEMBLY - CONTINUED
x.
Install new O-ring (85) on retainer (84).
y.
Install new seal (91) in retainer (84).
z.
Apply RTV compound on mating surfaces of retainer (84) and case (5).
aa.
Install retainer (84) on case (5) with three capscrews (81). Tighten capscrews alternately to 36 lb-ft (49 Nm).
NOTE
Sufficient shims to provide 0.003-0.007 in. (0.08-0.18 mm) end play on shaft are required.
ab. Install new shims (77) and input clutch bearing cage (75) on case (5) with four bolts (76). Tighten bolts to 36 lb-ft
(49 Nm).
ac.
Connect oil lines (64) (from control valve) to input clutch bearing cage (75).
ad. Assembly new O-ring (70), coupling (69), tees (68), elbows (67), adapter (66), reducer (65) and oil lines (64).
ae.
Connect oil lines (64) to case (5).
af.
Secure oil lines (64) with clips (63), washers (62) and bolts (61).
ag. Apply RTV compound to mating surface of access cover (73) and case (5).
ah. Install new gasket (74) and access cover (73) to case (5) with nine new lockwashers (72) and bolts (71). Tighten
bolts to 36 lb-ft (49 Nm).
ai.
Apply RTV compound to mating surfaces of access cover (57) and case (5).
aj.
Install new O-ring (59), spacer (60), new gasket (58) and access cover (57) to case (5) with nine washers (56) and
bolts (55). Tighten bolts to 36 lb-ft (49 Nm).
67 69 67
63 62 61
64
55
65,66
56
57
59
60
58
76 75
68
68
77
70
64
71
72
73
5
74
421-0214
Change 1
0245 19-34
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals