 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
WINCH ASSEMBLY REPAIR - CONTINUED
0245 19
ASSEMBLY - CONTINUED
CAUTION
Clutch shaft must be centered within 0.005 in. (0.13 mm) to allow same gear clearance (backlash) at each
bevel gear. Damage to equipment or mechanical failure may result if clutch shaft is not properly centered.
az.
After clutch shaft (155) is centered, measure and record distance between manifold (156) and case (5) with depth
ba. Remove four bolts (167) and manifold (156).
bb. Install new shims (168) and manifold (156), with a total shim thickness equal to value recorded in step az.
bc. Install nine bolts (167) to manifold (156). Tighten bolts to 36 lb-ft (49 Nm).
bd. Install plate (164) on end of clutch shaft (156) with two capscrews (163). Tighten capscrews to 36 lb-ft (49 Nm).
be. Install four new O-rings (162) and block (161) on manifold (156) with two bolts (160). Tighten bolts to 36 lb-ft (49
Nm).
bf.
Connect oil tubes (not shown) and install clamps (159) with two capscrews (158) and new locknuts (157).
143
166
160
172
158
157 159
170
169
171
168
162
127
117
161
162
165
156
5
117
155
173
116
164 174 167
163
115
421-0373
200
Change 1
0245 19-28
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals