|
|
TM 5-2410-237-23
WINCH ASSEMBLY REPAIR - CONTINUED
0245 19
DISASSEMBLY - CONTINUED
g.
Remove spiral retaining ring (14) and two-piece plate (15) that hold idler gear (16) on pinion gear (17) assembly.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.
NOTE
Pinion gear weighs 40 lb (18 kg).
Idler gear weighs 42 lb (19 kg).
h.
Pull pinion gear (17) assembly part way out of idler gear (16). Balance idler gear until pinion gear is out of the
way. Let idler gear roll slowly to one side against case (5). Remove pinion gear from case. Remove idler gear from
case.
i.
Use a bearing puller to remove bearing cones (18 and 19) from ends of pinion gear (17).
j.
Remove outer and inner bearing cups (20) from bearing cage (10) and from case (5).
10
20
19
14
15
5
16
17
18
20
421-0188
Change 1
0245 19-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |