|
|
TM 5-2410-237-23
TRANSMISSION OIL PUMP REPAIR - CONTINUED
0245 18
ASSEMBLY
NOTE
Lightly coat all transmission oil pump components with clean oil before assembly.
1.
If removed, install two dowels (17) on body (6). Dowels should protrude 0.19 in. (4.8 mm) above outer faces of body.
2.
Install new O-ring (16) on each of two plugs (15).
3.
Install two plugs (15) on manifold (7).
NOTE
Ensure that joints in bearing sleeves are installed at an angle of 30 15 degrees from centerline of two
bearing bores, in the direction of the groove in the surfaces of cover (5) and manifold (7).
Ensure bearing sleeves are installed to specified depth below machined surface of cover and manifold.
4.
Install two bearing sleeves (13) on cover (5). Bearings must be installed 0.062 in. (1.57 mm) below machined surface of
cover.
5.
Install two bearing sleeves (14) on manifold (7). Bearings must be installed 0.062 in. (1.57 mm) below machined sur-
face of manifold.
6.
Install new oil seal (12) on cover (5).
CAUTION
Use caution to ensure oil seal is not damaged when drive gear is installed.
7.
Install drive gear (10) and driven gear (11) in cover (5).
8.
Install new O-ring (8) on cover (5).
9.
Install new O-ring (9) on manifold (7).
10.
Align matchmarks and install body (6) and manifold (7) on cover (5).
11.
Loosely install ID tag (4), six washers (3), bolt (2) and five capscrews (1).
12.
Fully tighten capscrews (1) and bolt (2).
13.
Turn shaft of drive gear (10) to ensure gears turn freely by hand.
14.
Install protective caps on transmission oil pump.
Change 1
0245 18-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |