ASSEMBLY - CONTINUED - TM-5-2410-237-231466

TM 5-2410-237-23

TRANSMISSION ASSEMBLY REPAIR - CONTINUED

0245 15

ASSEMBLY - CONTINUED

NOTE

Clutch discs have friction material on both sides. Clutch plates are smooth and do not have friction mate-

rial on either side. Put clean oil on all clutch discs and clutch plates before assembly.

44.

Install ring gear (134) and 10 new springs (132).

45.

Install two new clutch discs (133) and new clutch

plate (135) on transfer gear case (19). Start and end

with clutch disc.

421-0245

NOTE

Apply thin coat of clean oil to rings.

46.

Install new rings (130 and 131) on No. 4 and No. 5 clutch housing (122) pistons (129).

47.

Install new rings (130 and 131) in No. 4 and No. 5 clutch housing (122).

48.

Install No. 5 piston (129) in No. 4 and No. 5 clutch housing (122).

49.

Install two clamps (WP 0244 01) so No. 5 piston (129) will not fall out.

50.

Turn No. 4 and No. 5 clutch housing (122) over.

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.

NOTE

Weight of No. 4 and No. 5 clutch housing is 100 lb (45 kg).

51.

Install two lifting links in No. 4 and No. 5 clutch housing (122) with l/2-13NC bolts, attach lifting device, and install

clutch housing in position. Remove two clamps

52.

Install No. 4 piston (129) in No. 4 and No. 5 clutch housing (122).

Change 1

0245 15-30