|
|
TM 5-2410-237-23
0245 07
REMOVAL
1.
Remove capscrew (1) and washer (2) from fuel pump drive gear (3). Discard washer.
2.
Remove fuel pump drive gear (3).
3.
Remove two capscrews (4) and plate (5).
NOTE
A new idler shaft will be installed. The new shaft diameter has been increased in the area that rides on the
bearing. This reduces the clearance between bearing and shaft. In order to reuse the same gears, old bear-
ing must be discarded and new one installed.
4.
Remove gear (6) and remove bearing (7) from gear. Discard bearing.
CAUTION
Do not reuse lock or nut. Bolt heads and nut could become embedded in the softer lock material causing a
possible loss of tightening torque. This could result in the failure of fuel pump drive idler shaft or thrust
plate.
5.
Remove two bolts (8), nut (9), and lock (10). Discard nut and lock.
NOTE
Idler shaft must be discarded. A new idler shaft will be installed. The new shaft has a longer pilot with a
larger pilot diameter for a light press fit into the block.
6.
Remove shaft (11). Discard shaft.
7.
Remove four capscrews (12) from camshaft gear (13) and remove camshaft gear.
3
11
2
7 9
1
10
8
5
4
6
12
13
421-0142
Change 1
0245 07-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |