 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
0245 04
DISASSEMBLY - CONTINUED
8.
Remove tooling and connecting rod. Lift ejector pin to
remove old piston pin bearing (14) from press.
14
EJECTOR PIN
421-0105
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is environmentally compliant and low toxic material.
However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-ventilated
areas. Keep away from open flames and others sources of ignition. Failure to follow this warning may cause
injury or death.
NOTE
Keep all related components together. Do not mix components.
1.
Clean all disassembled and cast components with solvent cleaning compound.
a.
Place all disassembled components in wire baskets for cleaning.
b.
Dry and cover all cleaned components.
c.
Place components on or in "racks" and hold for inspection or repair.
d.
Lightly oil and wrap all components subject to rusting.
e.
Clean inner and outer surfaces of castings and all areas subject to grease and oil with cleaning solvents.
f.
Use a stiff brush to remove sludge and gum deposits.
g.
Blow out all tapped (threaded) holes with compressed air to remove dirt and cleaning fluids.
h.
Dry machined surfaces with compressed air.
Change 1
0245 04-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals