 |
|||
|
|
|||
|
Page Title:
OPERATING/ADJUSTING HYDRAULIC JACK STANDS |
|
||
| ||||||||||
|
|
 TM 5-2410-237-23
GROUND HANDLING PROCEDURES - CONTINUED
0243 00
OPERATING/ADJUSTING HYDRAULIC JACK STANDS
1.
Assemble hydraulic jack stands as follows:
a.
Install extension tube (1) and collar (2) on jack
4
8
stand (3).
1
b.
Install hydraulic cylinder (4) in jack stand (3)
and under tab of collar (2).
2
c.
Repeat steps a and b for other jack stand (3).
d.
Connect hydraulic lines (5) from throttle valves
to each hydraulic cylinder (4).
e.
Connect hose (6) from valve tee to hydraulic
pump.
7
f.
Open both throttle valves and control valve on
hydraulic pump and ensure cylinders (4) are fully
3
retracted. If necessary, push down on extension
3
tube (1).
WARNING
THROTTLE
5
VALVES
Ensure all jack stands and blocking are
6
properly placed and secure, to prevent
movement of item to be lifted. Failure to
follow this precaution could result in seri-
ous injury or death.
CONTROL
VALVE
HYDRAULIC PUMP
387-478
2.
Put jack stand under area to be lifted. Ensure lifting point is sturdy.
JACKING POINT
JACKING POINT AT RIGHT-
REAR OF TRACTOR.
LEFT SIDE IS THE SAME.
387-939
0243 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals