|
|
TM 5-2410-237-23
ENGINE OIL PRESSURE GAGE REPLACEMENT - CONTINUED
0231 00
REMOVAL
1.
Remove four capscrews (1), washers (2), lockwashers (3) and cover (4) from top of dash assembly (5). Discard lock-
washers.
2.
Disconnect oil line (6) from connector (7) on back of tee (8). Cap oil line to keep line clean.
3.
Remove connector (7) from tee (8).
NOTE
Tag wires to ensure correct installation.
4.
Disconnect wires (9) and remove hourmeter switch (10) from tee (8).
5.
Remove tee (8) from back of oil pressure gage (11). Cap tee to keep clean.
6.
Remove two nuts (12), starwashers (13) and bracket (14).
7.
Slide oil pressure gage (11) with preformed packing (15) out through front of dash panel (16).
8.
Remove preformed packing (15) from oil pressure gage (11). Discard preformed packing.
7
6
8
5
10
4
1,2,3
9
9
12
13
14
387-045
16
15
387-382
11
INSTALLATION
1.
Install new preformed packing (15) on oil pressure gage (11).
2.
Insert oil pressure gage (11) into position on dash panel (16).
3.
Install bracket (14), two starwashers (13) and nuts (12) on back of gage (11).
4.
Wrap nipple on back of oil pressure gage (11) with antiseizing tape.
5.
Install tee (8) on oil pressure gage (11).
0231 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |