|
|
TM 5-2410-237-23
INSTALLATION OF ARMOR PACKAGE - CONTINUED
0228 00
INSTALLATION - CONTINUED
2.
Installation of Top and Rear Cab Plates.
NOTE
Use a suitable lifting device when installing the following components:
Top rear plate weighs approximately 185 lb (84 kg).
Lower rear plate weighs approximately 235 lb (107 kg).
Top front plate weighs approximately 121 lb (55 kg).
Top rear plate weighs approximately 180 lb (82 kg).
Front mounting bracket weighs approximately 51 lb (23 kg).
a.
Install top rear plate (15) with two existing bolts and four washers.
b.
Install lower rear plate (16) with two bolts (17) (1/2 x 1-1/2 in.) and washers (18).
c.
Install grommet (19) in lower plate (16).
d.
Install four bolts (17) and washers (18) to secure plates (15 and 16) together.
e.
Install left and right guard strips (20 and 21) with six bolts (22) (1/2 x 1.00 in.) and washers (23) on each side.
f.
Check dimension between left-top side plate rearmost mounting hole and top mounting bolt of left side guard strip
(20). Dimension must be 16.06-16.56 in. (40.8-42.1 cm). If measurement is correct, install remaining mounting
bolts and washers to secure rear top and lower plates (15 and 16). If measurement is not correct, it may be neces-
sary to loosen mounting bolts and relocate plates, retighten, and recheck measurement.
g.
Install left and right top side plates (24 and 25) with four bolts (17) to temporarily hold plates in place.
h.
Position cab top plates (26 and 27) on top of cab.
i.
Install six bolts (17), twelve washers (23) and six nuts (28) per side to secure cab top plates (26 and 27) to left and
right top side plates (24 and 25).
j.
Remove four bolts (17) (previously installed in step g) from each side plate (24 and 25).
k.
Install remaining four bolts (17), eight washers (23) and four nuts (28) to secure top plates (26 and 27).
l.
Install top front mounting bracket (29) with eight bolts (17), sixteen washers (23) and eight nuts (28).
0228 00-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |