 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
RIPPER LIFT CYLINDER REPAIR - CONTINUED
0224 00
ASSEMBLY - CONTINUED
12.
If removed, install grease fitting (14) on piston rod (13) and cylinder housing (2).
CAUTION
Protect piston rod and use care when placing in vise.
NOTE
Lightly coat threads on piston rod and piston with clean oil before assembly.
Ensure seal guide is installed on end of piston rod prior to assembly.
13.
Install piston (17) on piston rod (13).
14.
Install new self-locking nut (16) on piston rod (13) and tighten to 1620 lb-ft (2197 Nm).
15
14
1
15
16
2
14
11
12
13
17
15
387-730
NOTE
To ensure proper alignment and fit, ensure scribe marks on head and cylinder housing are in alignment.
15.
Install head (1) and piston rod (13) into cylinder housing (2).
NOTE
Tighten bolts evenly to draw head all the way on cylinder housing.
Piston rod must be fully extended when bolts are tightened for correct alignment of cylinder housing
and head.
16.
Install four washers (12) and bolts (11) on head (1) and tighten to 465 lb-ft (631 Nm).
0224 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals