 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
BLADE TILT AND RIPPER PILOT VALVE ASSEMBLY REPLACEMENT - CONTINUED
0204 00
WARNING
Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2500 psi (17,237
kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to the ground
and shut down engine. Move control levers through all operating positions, then SLOWLY loosen hydraulic
tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping hydraulic
fluid under pressure can penetrate the skin, causing serious injury or death.
REMOVAL
WARNING
Wipe area clean around all hydraulic connections to be opened during removal. Cap oil lines and plug
openings after removing lines. Contamination of hydraulic system could result in premature failure.
NOTE
Tag hydraulic lines to ensure correct installation.
Use a suitable container to catch any hydraulic oil that may drain from system. Dispose of oil IAW local
policy and ordinances. Ensure all spills are cleaned up.
1.
Remove four capscrews (1), washers (2), spacers (3)
and frame (4) from control housing (5).
4
1,2
3
387-603
5
2.
Disconnect two hoses (6) at front side of pilot valve assembly (7).
3.
Remove O-rings (8) from each hose (6) and discard.
4.
Disconnect two hoses (9) from blade tilt pilot valve (10) of pilot valve assembly (7).
0204 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals