REMOVAL - TM-5-2410-237-230950

TM 5-2410-237-23

WINCH ASSEMBLY REPLACEMENT - CONTINUED

0180 00

REMOVAL - CONTINUED

NOTE

Use a tap to chase and clean threaded holes in bosses to which chain end links are attached.

Attach lifting link with 3/4-10 x 1-1/2 in. bolt in threaded boss (1) on each side of winch (2).

Remove two capscrews (3) and lockwashers (4). Discard lockwashers.

Remove seven remaining capscrews (5) and lockwashers (6) from cover (7) and cable access opening (8). Discard lock-

washers.

Remove gasket (9) and O-ring (10) from cover (7). Discard gasket and O-ring.

Remove two self-locking nuts (11) and washers (12) from two top inner studs (13). Discard self-locking nuts.

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to

personnel.

NOTE

Winch assembly weighs approximately 3600 lb (1634 kg).

10.

Attach a suitable three-point lifting device to each lifting link and to bar (14).

11.

Remove six self-locking nuts (15) and washers (16) from studs (17). Discard self-locking nuts.

CAUTION

Remove winch slowly and carefully to prevent damage to mounting studs, transmission and drive

shaft.

Adjust lifting device as necessary to remove load from mounting studs.

12.

Use lifting device to move winch (2) straight back until drive shaft (18) is clear of tractor.

13.

Place winch (2) on wood cribbing to prevent tipping.

CAUTION

Cover and gasket must be installed to prevent dirt and other damaging contaminants from entering final

drive case.

NOTE

Round cover, gasket and mounting hardware are COEI items listed in TM 5-2410-237-10.

14.

Install gasket (19) and round cover (20) over opening in final drive case at rear of tractor. Secure with nine lockwashers

(21) and capscrews (22).

0180 00-2