 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
SEAT HINGE MAINTENANCE - CONTINUED
0173 00
DISASSEMBLY
1.
Remove cotter pin (6) and pin (7) from back end of rod assembly (8). Discard cotter pin.
2.
Remove capscrew (9), washer (10) and plate (11) from back end of rod assembly (8).
3.
Remove two plates (12) from rod assembly (8) and hinge plate (13).
4.
Remove two capscrews (14), washers (15), plate (16) and rod assembly (8) from hinge plate (13).
NOTE
Perform steps 5-7 for each latch assembly.
5.
Remove self-locking nut (17) at front end of latch assembly (18). Discard self-locking nut.
6.
Remove latch assembly (18) through back end of hinge plate (13).
7.
Remove spring (19) from latch assembly (18).
18
19
13
7
6
17
8
12
16
11
15
10
14
12
9
387-370
ASSEMBLY
NOTE
Perform steps 1-4 for each latch assembly.
1.
Install spring (19) on latch assembly (18).
2.
Insert latch assembly (18) into back of hinge plate (13) with threaded rod through hole in front of hinge plate.
3.
Install new self-locking nut (17) on front end of latch assembly (18).
4.
Adjust self-locking nuts (17) on latch assembly (18) so that latch assembly extends 0.8 in. (20.3 mm) beyond hinge plate
(13).
5.
Install rod assembly (8) in hinge plate (13) with plate (16), two capscrews (14) and washers (15).
6.
Install pin (7) in rod assembly (8).
7.
Install two plates (12) in hinge plate (13) and on pin (7) of rod assembly (8).
8.
Install plate (11), washer (10) and capscrew (9) on rod assembly (8).
9.
Install new cotter pin (6) in pin (7).
0173 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals