 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
WINDSHIELD GLASS REPLACEMENT - CONTINUED
0169 00
INSTALLATION
WARNING
Wear gloves and handle glass carefully to avoid personal injury.
1.
Install new seal (2) around circumference of window opening. Start along side of window panel. Install edge (4) of seal
over panel (5) with locking lip toward outside of cab.
2.
Cut seal (2) to extend past starting point by 1/8 in. (3.2 mm) per foot of window opening circumference.
3.
Push ends of seal (2) together and push them over panel (5) to make a tight, smooth joint.
NOTE
When glass is installed, edge (6) must be over glass (3).
4.
Put lower corner of glass (3) in channel of seal (2) as
far as possible. Do not use too much force.
5.
Moving in both directions from starting point, lift
3
glass channel lip and glass will slip into place.
6
6.
Put a solution of soap and water on locking lip of seal
(2).
7.
Install curved end of seal installer (1) between locking
2
lip and its groove at any point away from seal (2) joint.
8.
Move seal installer (1) along groove completely
around circumference of seal (2). Rubber lip will lock
into position around circumference of glass (3).
4
5
387-314
END OF WORK PACKAGE
0169 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals