 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
ROLLOVER PROTECTIVE STRUCTURE (ROPS) REPLACEMENT - CONTINUED
0164 00
INSTALLATION
NOTE
If ROPS has been replaced, notify Direct Support Maintenance to install protective screen angle
mounted brackets by welding (WP 0166 00).
Apply antiseize compound to all mounting bolts and capscrews before installation.
Steps 1 and 2 apply to both right and left hand pads.
1.
Install rear mounting pad (17) and two bushings (16) to rear leg of ROPS (8) with bolt (13), two washers (15) and nut
(14).
2.
Install front mounting pad (7) and two bushings (12) to front leg of ROPS (8) with bolt (9), two washers (10) and nut
(11).
3.
Attach a suitable lifting device to ROPS (8) and lift ROPS into position on tractor.
4.
Install three bolts (5) and washers (6) on each side of tractor to front mounting pad (7) and ROPS (8).
5.
Install four capscrews (1), washers (2) and two nut strips (3) to each side of rear mounting pads (4) on tractor and ROPS
(8).
6.
Evenly tighten capscrews (1 and 13) and bolts (5 and 14) to 900 lb-ft (1220 Nm).
7.
If equipped, install protective screen (WP 0167 00).
END OF WORK PACKAGE
0164 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals