 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRACK DRIVE SPROCKET/HUB REPLACEMENT - CONTINUED
0141 00
INSTALLATION - CONTINUED
6.
Install sleeve (47) over stud (34) and adapter (31) until it makes contact with sprocket (27).
7.
Install plate (35) on stud (34) until it makes contact with sleeve (47).
8.
Install retracted cylinder (36) on stud (34) until it makes contact with plate (35). Piston end of cylinder should face away
from sprocket (27).
9.
Install nut (41) on stud (34) to within 1 in. (2.54 cm) of cylinder (36).
10.
Connect hydraulic pump to cylinder (36) and apply 60-65 tons of pressure to force sprocket (27) fully onto drive hub.
34
27
35
36
27
34
387-669
31
47
387-670
41
47
WARNING
Make sure pressure is off cylinder of sprocket installation tool before trying to remove tooling. Failure to
follow this precaution could result in serious personal injury.
11.
Remove sprocket installation tooling.
12.
Check distance from hub face of sprocket (27) to spline shoulder on final drive gear hub. Dimension (A) must be 0.500
+/- 0.060 in. (12.7 +/- 1.52 mm).
13.
If distance measured in step 12 is less than 0.44 in.
(11.18 mm), replace sprocket (27) and final drive gear
hub. If distance exceeds 0.560 in. (14.22 mm), remove
sprocket, clean hub splines and reinstall sprocket.
27
GEAR
HUB
A
387-671
0141 00-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals