|
|
TM 5-2410-237-23
TRACK DRIVE SPROCKET/HUB REPLACEMENT - CONTINUED
0141 00
REMOVAL - CONTINUED
31.
Remove seal assembly (42) and preformed packing (43) from hub of sprocket (27). Discard seal assembly and pre-
formed packing.
32.
Remove seal assembly (44) and preformed packing (45) from final drive (46). Discard seal assembly and preformed
packing.
46 44,45
27
387-667
387-668
42,43
CLEANING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
serious injury or death. Make sure air stream is directed away from user and other personnel in the
area. To prevent injury, user must wear protective goggles or face shield.
1.
Clean all removed components with solvent cleaning compound.
2.
Thoroughly dry components with compressed air or clean rags.
3.
Ensure mating surfaces in final drive are clean.
INSPECTION
1.
Inspect all removed components IAW WP 0241 00.
2.
Ensure mating surfaces in final drive are free of damage.
0141 00-7
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |