|
|
TM 5-2410-237-23
TRACK DRIVE SPROCKET/HUB REPLACEMENT - CONTINUED
0141 00
REMOVAL - CONTINUED
21.
Install an adapter (31) on drive hub and turn to within
0.25 in. (6.3 mm) of sprocket (27).
22.
Install three adapters (32) in three puller holes in
33
sprocket (27).
23.
Install three nuts (33) on adapters (32) with angle side
toward sprocket (27) and flat side even with threaded
32
end of adapter (31). Position drill point on nut toward
outer edge of sprocket.
27
31
387-664
24.
Install stud (34) in adapter (31).
31
35
25.
Install plate (35) and cylinder (36) on stud (34) and
against adapter (31). Piston end of cylinder should
face away from sprocket (27).
32
34
27
36
387-665
0141 00-5
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |