 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
RECOIL SPRING REPLACEMENT - CONTINUED
0136 00
INSTALLATION - CONTINUED
3
6
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Recoil spring weighs 300 lb (136 kg).
2.
Attach a nylon sling and a suitable lifting device and position recoil spring (6) in track roller frame.
3.
Install spacers (9) and recoil front stops (5) in position.
4.
Install four new lockwashers (8), and capscrews (7) securing two front stops (5). Tighten capscrews to 200 lb-ft (271
Nm).
5.
Install washer (2) and bolt (1).
6.
Loosen recoil spring compression nut (3) until it extends 0.06 in. (1.5 mm) past end of bolt.
3
1
387-913
2
0136 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals