 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
FINAL DRIVE PINIONS AND FLANGES MAINTENANCE - CONTINUED
0126 00
ASSEMBLY - CONTINUED
WARNING
Keep hands clear of puller when installing flange. Failure to do so could cause personal injury.
9.
Position flange (1) on splines of final drive pinion (6) shaft, install puller, and press flange on final drive pinion shaft
with a force of 35-40 tons. Remove puller.
10.
Measure distance from shoulder on final drive pinion (6) shaft to hub face in center of flange (1). This distance must be
0.12 in. +/- 0.03 in. (3.15 mm +/- 0.80 mm).
11.
If distance in step 10 is less than 0.09 in. (2.29 mm), replace flange (1) and final drive pinion (4). If distance exceeds
0.15 in. (3.81 mm), remove flange and clean final drive pinion and shaft splines. Reinstall flange.
12.
Install new gasket (9) in hub of flange (1).
13.
Install lock (8) on flange (1) with capscrew (7).
NOTE
Nut (2) is tightened and lock (8) is bent to secure nut after final drive pinion and flange assembly is installed
in bevel gear case.
14.
Install nut (2) on shaft of final drive pinion (6) finger tight.
1
7
11
4
6
2
8
9
11
0.12 IN. +/- 0.03 IN.
(3.15 MM +/- 0.80 MM)
10
6
1
387-781
0126 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals