|
|
TM 5-2410-237-23
PRIMARY FUEL FILTER ASSEMBLY MAINTENANCE - CONTINUED
0059 00
FILTER ELEMENT SERVICE - CONTINUED
7.
Inspect filter element (6) for dents, contamination, or other damage. Replace if damaged.
8.
Place filter element (6) onto stud in filter case (2).
9.
Coat new gasket (5) with fuel and position on filter case (2).
10.
Position filter case (2) onto filter base (4) and hand tighten nut (3) until filter case is snug against filter base.
CAUTION
Do NOT overtighten or fuel leaks could result.
11.
Hold filter case (2) and wrench-tighten nut (3) an additional 3/4 turn.
12.
Open fuel shutoff valve (1).
13.
Prime fuel system (WP 0041 00).
14.
Check for any leaks by visually inspecting area.
PRIMARY FUEL FILTER ASSEMBLY REMOVAL
1.
Remove filter case and filter element. See Filter Element Service in this work package.
2.
Remove fuel priming pump (WP 0041 00).
3.
Disconnect fuel lines from filter base (WP 0053 00).
4.
Remove two capscrews (7), four washers (8) and two nuts (9). Remove filter base (4) from support assembly (10).
5.
If removal of support assembly (10) is required,
11,12,13
remove six capscrews (11), washers (12) and nuts (13)
7,8,9
10
that secure support assembly to muffler and engine.
11,12,13
4
387-216
0059 00-3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |