 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
GOVERNOR CONTROLS AND LINKAGE MAINTENANCE - CONTINUED
0058 00
REMOVAL - CONTINUED
2.
Remove cotter pin (6), pin (7) and separate end of rod (8) from lever (9) on hand lever (10). Discard cotter pin.
3.
Repeat step 2 at other end of rod (8) assembly and remove rod from dash assembly (5).
4.
Loosen jam nut (11) at each end of rod (8) assembly and remove rod end (12) and jam nut from each end of rod.
5.
Remove capscrew (13) from lever (9) on hand lever (10).
NOTE
Drive small chisel into slot in levers on shafts to open them up for removal.
6.
Remove lever (9), key (14) and spacer (15) from hand lever (10) and remove hand lever from side of dash assembly (5).
7.
Remove capscrew (16) from lever (17) on shaft assembly at back of dash.
8.
Remove lever (17) and key (18) from shaft assembly.
9.
Remove capscrew (19) and nut (20) from back of dash assembly (5).
6
11 8
12
11 12
6
7
7
9
10
DASH
AREA
20 19
DASH
16
ASSY
17
18
13
14
15
MOUNTED ON
FLYWHEEL
387-425
MOUNTED ON
HOUSING
GOVERNOR
10.
Remove two nuts (21) and capscrew (22) from decelerator pedal (23) and rod (24).
11.
Remove stop setscrew (25), washer (26) and nut (27) from lower front of dash assembly (5).
12.
Remove cotter pin (28), pin (29) and upper end of rod (30) from lever (31) at back of dash. Discard cotter pin.
13.
Remove capscrew (32), lever (31) and key (33) from shaft (34).
14.
Remove spring (35) from lower end of rod (30) and strip (36).
15.
Remove cotter pin (28), pin (29), washer (37), strip (36), spacer (38) and rod (30) from bellcrank (39). Discard cotter
pin.
16.
Remove rod (40) from rod (30). Remove rod end (41) and jam nut (42) from rod (40).
0058 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals