|
|
TM 5-2410-237-23
STE/ICE TROUBLESHOOTING PROCEDURES - CONTINUED
0007 00
STE/ICE TESTING PROCEDURE
1.
The VTM provides a method to test the D7G electrical and mechanical components. Readings are either GO/NO-GO
(pass/fail) indications or digital displays in units (psi, rpm, volts, ohms, amps, etc.).
2.
The diagnostic connector assembly (DCA) is mounted beneath the dashboard and provides access to the most frequently
needed test points.
3.
Use of the VTM through the DCA is referred to as the DCA Mode GO-Chain Tests.
4.
When the VTM interfaces with the tractor through the use of the transducer kit, the use of the VTM is referred to as the
TK Mode GO-Chain Tests.
5.
The DCA and TK Modes can be used at the same time.
0007 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |