|
| |
TM5-2410-237-10
NOTE
Control lever may need to be cycled
several times to relieve pressure in
hydraulic system.
(4) Disconnect hydraulic hoses at rod end
of ripper hydraulic cylinders.
(5) Remove ripper shank retaining pins.
(6) Raise ripper beam to height that will
clear ripper shanks using any
convenient lifting device (ie: lift truck,
crane, winch, etc.).
NOTE
Hydraulic oil will be displaced from
hydraulic cylinder.
(7) Move ripper shanks clear of ripper
beam.
(8) Lower ripper beam.
(9) Reconnect hydraulic hoses to ripper
cylinders.
(10) Reassemble ripper shanks into ripper
beam in inverted position.
2-52
|
