 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 compartment before removing the idler pinion
(9) Attach a puller to the idler pinion and
remove.
inner bearing cage (3).
(10) Inspect idler pinion outer race and roller
(14) Using two 1/2 inch 13 NC forcing
assembly.
screws (5), remove bearing cage (3). Inspect the
bearing cage-to-steering clutch case gasket.
(11) Using a puller, a bearing pulling at-
tachment, a hydraulic puller, a pump group, and a
(15) Using a 1/4 inch 20 NC bolt, remove
dowel (2, fig, 6-134) and remove outer race and
spacer, remove inner race. The idler pinion inner
bearing inner race can be removed in a like manner.
roller assembly (1).
NOTE
NOTE
Heat bearings races to facilitate removal.
When installing bearing cage
(3, fig. 6-133) in tbe
steering clutch and bevel gear
case, position dowel to
(12) Remove the bolts and locks (1, fig. 6-
tbe top and oil drain passage
(6) in the cage to the
bottom. Final drive pinion (2)
and bearings are serv-
133).
iced after the steering clutch
and final drive pinion
(13) Drain the oil in the steering clutch
flange have been removed.
6-107
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals