ASSEMBLY - CONTINUED - TM-5-2410-233-230750

TM 5-2410-233-23

BLADE TILT CYLINDER REPAIR - CONTINUED

0155 00

ASSEMBLY - CONTINUED

Place head (1) on cylinder housing (2) and install two capscrews (3) to hold head in place.

CAUTION

Piston rod must be supported and kept level at all times to avoid damaging seals in head.

Place seal guide on piston end of piston rod (5). Push piston rod into head (1) as far as possible.

Remove two capscrews (3) and separate head (1) and piston rod (5) as a unit from cylinder housing (2).

CAUTION

Protect piston rod and use care when placing in vise.

NOTE

Lightly coat threads of piston rod and piston with clean oil before assembly.

Ensure seal guide is installed on end of piston rod before assembly.

10.

Install piston (7) on piston rod (5).

11.

Install new self-locking nut (8) on piston rod (5) and tighten to 1600 lb-ft (2169 Nm).

NOTE

To ensure proper alignment and fit, ensure scribe marks on head and cylinder housing are in alignment.

12.

Install head (1) and piston rod (5) into cylinder housing (2).

NOTE

Tighten capscrews evenly to draw head all the way on cylinder housing.

Piston rod must be fully extended when capscrews are tightened for correct alignment of cyl-

inder housing and head.

13.

Install four new lockwashers (4) and capscrews (3) on head (1). Tighten capscrews to 265 lb-ft (359 Nm).

0155 00-6