 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
WINCH WIRE ROPE ASSEMBLY MAINTENANCE - CONTINUED
0145 00
CLEANING AND INSPECTION
WARNING
Wear eye protection when using wire brush to protect against injury.
Failure to replace a damaged wire rope assembly could result in injury or death in the event
wire rope breaks when loaded.
NOTE
Refer to FM 5-125, Rigging Techniques, Procedures, and Applications for further information.
1.
Clean entire length of wire rope with a wire brush.
2.
Inspect entire length of wire rope for flat spots, fraying, kinks and evidence of rusting.
3.
Replace wire rope if any frays or kinks are evident, or if any flat spot is more than 1/2 the diameter of wire rope.
ASSEMBLY
WARNING
Wear eye protection when assembling latch to prevent injury.
1.
Position latch (12) and two springs (13) to hook (9).
2.
Install screw (11) through hook (9), springs (13) and latch (12) and secure with nut (10).
3.
Position clevis (8) in loop at end of wire rope (6).
4.
Position eye of hook (9) in clevis (8) and install pin (7).
INSTALLATION
1.
Lay wire rope (6) in a straight line behind tractor.
1
2
3
NOTE
4
When installing wire rope for standard speed
winch, ensure wire rope is wound over top of
winch drum.
2.
Position one end of wire rope (6) on winch drum (5).
3.
Install filler (4) and wire rope ferrule (3) over end of
wire rope (6) on winch drum (5).
6
4.
Install new lockwasher (2) and capscrew (1).
5.
Start engine and wind wire rope on drum (TM 5-2410-
233-10).
5
386-050
END OF WORK PACKAGE
0145 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals