 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
STEERING CLUTCH ASSEMBLY MAINTENANCE - CONTINUED
0127 00
INSTALLATION
1.
Install two 3/8 in. -16NC x 4 in. long rods (8) through brake band (9) clamps and secure rods with two 3/8 in. -16 hex
nuts (10).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Steering clutch assembly weighs 250 lb (104 kg).
Ensure steering clutch stays level so that clutch does not come apart.
2.
Attach a nylon sling and suitable lifting device to rods
3,4
(8) in brake band (9). Lift steering clutch (5) assembly
into clutch case (2) between hub and flange.
3.
Put antiseize compound on threads of all capscrews (3
10
and 6).
4.
Install one capscrew (3) and washer (4) on hub side of
5
steering clutch (5). Tighten capscrew to 200 lb-ft (271
Nm).
5.
Install one capscrew (6) and washer (7) on flange side
8
of steering clutch (5). Tighten capscrew to 200 lb-ft
(271 Nm).
6.
Remove lifting equipment, two nuts (10) and rods (8).
2
9
386-366
6,7
0127 00-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals