 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
STEERING CLUTCH ASSEMBLY MAINTENANCE - CONTINUED
0127 00
ASSEMBLY
1.
Install plate on steering clutch stand. Position retainer
15
(21) on plate.
2.
Install eight outer spring (18), inner springs (19) and
16
sleeves (20) onto retainer (21).
17
WARNING
Use extreme caution when handling heavy
parts. Provide adequate support and use assis-
18
tance during procedure. Ensure that any lifting
device used is in good condition and of suitable
load capacity. Keep clear of heavy parts sup-
19
ported only by lifting device. Failure to follow
this warning may result in injury or death to
20
personnel.
21
NOTE
Inner drum weighs 50 lb (23 kg).
386-369
3.
Use lifting device to install inner drum (17).
NOTE
If assembling same disc assemblies and discs as
12
were disassembled, install disc assemblies and
discs in reverse order of disassembly, to ensure
better wear distribution. For example, top is
13
now installed on bottom.
4.
Beginning with a disc assembly (15), alternately
install 12 disc assemblies and 11 discs (16).
14
5.
Install two lifting links with 1/2-13 x 1 in. bolt to pres-
sure plate (14). Use a nylon sling and lifting device to
17
install pressure plate, with bolt holes aligned with bolt
holes in inner drum (17). Remove lifting links.
6.
Position four new lock plates (13) and eight bolts (12)
5
in steering clutch (5).
7.
Position compressor plate on pressure plate (14) and
secure with retaining nut.
386-368
8.
Compress steering clutch (5) and tighten eight bolts
(12) to 150 lb-ft (203 Nm).
9.
Bend down lock plates (13).
0127 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals