 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
STEERING BRAKE ACTUATING MECHANISM MAINTENANCE - CONTINUED
0125 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning, compound MIL-PRF-680 Type III is an environmentally compliant and low toxic mate-
rial. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-venti-
lated areas. Keep away from open flames and other sources of ignition.
1.
Clean all removed components in solvent cleaning compound.
2.
Wipe components clean with a rag.
3.
Inspect for bends, breaks, cracks, corrosion or other damage.
4.
Replace any damaged component.
ASSEMBLY
NOTE
For ease of assembly, position actuating mechanism securely on wood blocks 4-6 in. (10-15 cm) above work
surface.
1.
Install shim (61), plate (62), lockplate (60) and two capscrews (59) on end of actuating mechanism (2). Bend lockplate.
NOTE
All bearings must be centered from side to side in bearing holes.
2.
Install two larger bearings (58) and smaller bearing (57) in lever (47).
3.
Install adjusting screw (56) through top of lever (47) and install wedge (55) in bottom of lever until it contacts end of
adjusting screw.
4.
Install spring (54) with new lockwasher (53) and capscrew (52) in wedge (55), with open end of spring in groove at end
of adjusting screw (56).
5.
Install socket (1) over adjusting screw (56). Secure socket with spring (51), two capscrews (50), lock (48) and two nuts
(49) on lever (47).
0125 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals