 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TORQUE DIVIDER OUTPUT SHAFT SEAL REPLACEMENT - CONTINUED
0091 00
INSTALLATION
NOTE
Apply clean grease to new seal before installation.
Ensure flat side of seal faces transmission when installing.
1.
Install new seal (5) into torque divider housing (6).
2.
Install flange (4) onto output shaft (3) until fully seated.
WARNING
Exposure to silicone RTV compound may be hazardous to your health. Contact with eyes can cause severe
irritation and burns. Compound can be absorbed into the skin nd can cause irritation or skin sensitization.
Inhalation of vapors can cause respiratory tract irritation; prolonged inhalation can result in an allergic
reaction. Vapors are combustible. Do not use near open flame. Wear eye and skin protection and avoid
inhalation of vapors. Use only in a well-ventilated area. Failure to follow this warning can cause injury or
death.
3.
Apply silicone RTV compound to underside of washer
6
(2). Install washer and capscrew (1). Tighten capscrew
to 40 lb-ft (54 Nm).
4.
Install driveshaft (WP 0106 00). DO NOT install floor
plates.
5.
Check level of oil in transmission and add as needed
5
4
2
6.
Test drive and check torque divider for proper opera-
tion and leaks (TM 5-2410-233-10).
1
7.
Install floor plates (WP 0135 00).
3
386-383
END OF WORK PACKAGE
0091 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals